Stránka 1 z 1
X-Trend ET 9200 a univerzálne dialkové
Napsal: 27 dub 2014, 22:30
od Brandy20
Zdravím, nevie niekto ako sa na originalnom dialkovom od ET 9200 nastavuje TV. Dakujem
Re: X-Trend ET 9200 a univerzálne dialkové
Napsal: 28 dub 2014, 05:27
od dym1
Stlac TV + OK aby zostalo svietit tlacitko TV na cerveno. Potom sipku hore na kruhovom ovladaci mackaj kym sa Telka nevypne. Po vypnuti TV stlac OK a hotovo. Na plazme od LG sa to nepodarilo.
Re: X-Trend ET 9200 a univerzálne dialkové
Napsal: 28 dub 2014, 12:59
od Brandy20
No ovládačka funguje na LCD od Samsungu, ale ten nepoužívam s prímačom. A to čo si písal som skúšal na LED Panasonic a neúspešne
Re: X-Trend ET 9200 a univerzálne dialkové
Napsal: 28 dub 2014, 22:19
od Brandy20
1-2. Settings method
A. 3-DIGIT Setup Method
1) Turn on the device that you want to setup (for example turn on TV)
2) Press and hold [DEVICE] + [OK] button more than 2 seconds until the device LED blinks.
If there is no key input for 20secnds, the Remote Control will exit the setting mode and return to normal
mode.
3) Enter the 3-Digit setup code from the Brand list. (The LED will blink by Key input)
When the 3-Digit setup code is input, the designated Power Code will be output. (LED blinks)
Verify whether it operated properly by pressing the [Power] button. (If the device does not operate
properly, press next 3-Digit setup code)
In case the 3-Digit setup code is not valid, the LED will off for 1.5seconds and revert to on status for input
mode.
It does not answer against key input other than [OK], [0~9], [CH+], [CH-], [Power] key.
4) Press [OK] button to save and exit the setup model. (LED will blink 2 times and off)
B. Auto Search (CH+, CH-) Setup method
1) Turn on the device that you want to setup (for example turn on TV)
2) Press and hold [DEVICE] + [OK] button more than 2 seconds until the device LED blinks.
If there is no key input for 20secnds, the Remote Control will exit the setting mode and return to normal
mode.
3) Press [CH+] or [CH-] button. By pressing the button, the power code of next setting number will be output.
(LED blinks)
It does not answer against key input other than [OK], [0~9], [CH+], [CH-], [Power] key.
4) Press [OK] button to save and exit the setup model. (LED will blink 2 times and off)
1-3. Setup Code Read Out (Number Call)
1) Press and hold [DEVICE] + [OK] button more than 2 seconds until the device LED blinks.
If there is no key input for 20secnds, the Remote Control will exit the setting mode and return to normal
mode.
2) Press [INFO] button. LED will blink the number of times as setup code.
0: LED blinks quickly 10 times.
1~9: LED blinks the number of digit.